Building Automation
Industrial Automation
Power Automation & Safety
Bangladesh Distributor
Question
Is it acceptable to wire 61F's Floatless Level Controller electrode cable and power cable in the same duct?
Answer
There is a possibility of improper operation, so avoid wiring the cables in the same duct or close together.
Since there is a weak current (about 1 mA at 8 VAC) between the 61F Controller and the electrodes, the electrode cables can be affected by inductive noise from the power cable and operate improperly. Also, be sure to check that the common electrode is grounded properly.
Recommended Products
Other Level Switches FAQ
-
Why do the specifications for the High-sensitivity 61F Floatless Level Controller say, "possible to use with 15 kOHM or less, however, this may cause reset failure"?
-
Can two 61F Floatless Level Controllers and two Electrode Holders be used in the same tank?
-
When voltage is applied to 61F Floatless Level Controller, it operates regardless of the actual liquid level. What is the cause of the problem and how can it be corrected?
FAQ
Top of page
© Copyright Kyoto Engineering & Automation Ltd. All Rights Reserved.
