Building Automation
Industrial Automation
Power Automation & Safety
Bangladesh Distributor
Question
Can Factory Automation System Integrated Tool Package "CX-One CX-Programmer" and Drawing Tool for CX-One NS Series "NS-Designer" be connected with the Programmable Controllers (PLC) by using a USB port built into the personal computer?
Answer
Use the D-sub to USB-Serial Conversion Cable "CS1W-CIF31". This cable can connect the Programmable Logic Controller "SYSMAC" and/or the Programmable Terminal "NT/NS Series" with the support software.
Since Windows softwares including the CX-Programmer and the NS-Designer use the Windows COM port which does not depend on its physical configuration: RS-232C or USB port, either connector can be used. However, since the performance of a commercially-available simple USB-RS232C conversion connector for hobby use may not meet the high-speed communication, utilize a USB conversion cable suitable for FA use
* "Windows" is a registered trademark of Microsoft Corporation.
Recommended Products
Other Programmable Controllers FAQ
-
What products are recommended as substitutes for the C200H-CPU01 Programmable Controller?
-
How can I connect a C200H Programmable Controller's CPU Unit with an IBM PC/AT or compatible computer?
-
Why communication error occurs during CX-Programmer FA Integrated Tool Package get online with Programmable Controller?
FAQ
Top of page