Building Automation
Industrial Automation
Power Automation & Safety
Bangladesh Distributor
Question
Can I use an external signal to release the brake of a U-series AC Servomotor equipped with a brake?
Answer
We recommend using the brake interlock signal.
Open the connector case on the Servo side of the cable and add the brake interlock signal there.
Often, a Programmable Controller output is used as a brake signal, but because it is difficult to time the signal accurately, this method may cause falling on a vertical axis and excessive brake wear, due to the brake being applied when the motor cannot be stopped or the brake being released before the servo lock can be applied.
Recommended Products
CS1W-NC[]71
Decrease TCO with Simple Operation, Reduced Wiring, Batch Settings, and Batch Management
CJ2
Introducing the Flagship CJ2 CPU Units, with Built-in Multifunctional Ethernet Port.
FAQ
Top of page