Building Automation
Industrial Automation
Power Automation & Safety
Bangladesh Distributor
Question
An AC voltage of 200V was applied to a coil with rated voltage of 100VAC. Is there any problem?
Answer
Yes. When an AC voltage of 200V is applied to a coil with rated voltage of 100VAC,problems such as coil burnout may occur. As for problems caused by other incorrect voltage applications, refer to the following table.
Be careful not to apply other voltages than the rated voltage.
Recommended Products
MY
New Latching Levers for Circuit Checking Added to Our Best-selling MY General-purpose Relays
LY
Power-switching Compact General-purpose Relays
G3PE (Three-phase)
Compact, Slim-profile SSRs with Heat Sinks. Solid State Contactors for Three-phase Heaters Reduced Installation Work with DIN Track Mounting.
Other General Purpose Relays FAQ
-
The Relay does not operate even when voltage is applied. Why is this?
-
We were using G2R General Purpose Relay to turn a solenoid valve ON and OFF, and sparks at the contact damaged the relay after only about 3 months of use. What caused this, and what kind of countermeasure is there for it?
-
A Relay burned out. Why is this?
FAQ
Top of page