Type | Digital display and direct key setting | |
---|---|---|
Standard models | ||
Model | E3X-SD[] | |
Light source (wavelength) | Red LED (620 nm) | |
Power supply voltage | 12 to 24 VDC ±10%, ripple (p-p): 10% max. | |
Current consumption | 960 mW max. (Power supply: 24 V, Current consumption: 40 mA max.) | |
Control output | Open-collector output (NPN or PNP)
Load power supply: 26.4 V max., Load current: 50 mA max. (Residual voltage: 1.5 V max.) Light-ON/Dark-ON mode selector |
|
Response time | Operate or reset: 200 μs max. | |
Sensitivity adjustment | UP/DOWN direct key setting, teaching | |
Protection circuits | Power supply reverse polarity protection, output short-circuit protection, output
reverse polarity protection |
|
Timer function | ON/OFF-delay timer: 10 ms (each fixed) | |
Mutual interference
prevention |
Up to 5 Amplifiers (optically synchronized) | |
Ambient illumination | Receiver side
Incandescent lamp: 10,000 lux max. Sunlight: 20,000 lux max. |
|
Ambient temperature range | Operating:
Groups of 1 to 3 Amplifiers: -25°C to 55°C Groups of 4 to 11 Amplifiers: -25°C to 50°C Groups of 12 to 16 Amplifiers: -25°C to 45°C Storage: -30°C to 70°C (with no icing or condensation) |
|
Ambient humidity range | Operating and storage: 35% to 85% (with no condensation) | |
Insulation resistance | 20 MΩ. min. (at 500 VDC) | |
Dielectric strength | 1,000 VAC at 50/60 Hz for 1 minute (*) | |
Vibration resistance | Destruction: 10 to 55 Hz with a 1.5-mm double amplitude for 2 hrs each in X, Y and Z
directions |
|
Shock resistance | Destruction: 500 m/s2, for 3 times each in X, Y and Z directions | |
Degree of protection | IEC 60529 IP50 (with Protective Cover attached) | |
Connection method | Pre-wired (standard cable length: 2 m), or connector | |
Weight (packed state) | Pre-wired model: Approx. 100 g, Model with connector: Approx. 55 g | |
Material | Case | Polybutylene terephthalate (PBT) |
Cover | Polycarbonate | |
Accessories | Instruction manual |