A

Use M4 mounting screws with plane washers or spring washers to securely mount the Switch. Tighten the screws to a torque of 1.18 to 1.47 Nm.

The Switch can be panel mounted, provided that the hexagonal nut of the actuator is tightened to a torque of 2.94 to 4.9 Nm.

The models, illustrations, and graphics are for screw-terminal models. (The dimensions for models that are omitted here are the same as for pin-plunger models.)

Note: Do not use both M12 mounting screw and mounting holes at the same time.

Note: Do not use both M12 mounting screw and mounting holes at the same time.

Note: Do not use both M12 mounting screw and mounting holes at the same time.

Note: Unless otherwise specified, a tolerance of ±0.4 mm applies to all dimensions.

Note: Unless otherwise specified, a tolerance of ±0.4 mm applies to all dimensions.

Soldering Terminal Use (Phenol Resin)

Note: The Cover has five thin, easy-to-separate portions for easy lead wire connections.

Screw Terminal Use (Phenol Resin)

Note: The Cover has six thin, easy-to-separate portions for easy lead wire connections.

Soldering Terminal Use (Metal Press Mold)

Note: The Cover has five holes for easy lead wire connections.

Screw Terminal Use (Metal Press Mold)

Note: The Cover has six holes for easy lead wire connections.

Soldering or Screw Terminal Use (Vinyl Chloride)

Note: Each dimension has a tolerance of ±0.4 mm unless otherwise specified. (±0.8 mm for the AP-Z)

Note: 1. Each dimension has a tolerance of ±0.4 mm unless otherwise specified.
          2. The material is EAVTC (Epoxide Alkyd Varnished Tetron Cloth) and its heat-resisting temperature is 130°C.