Rated power
supply voltage |
12 to 24 VDC (Allowable voltage fluctuation range: 10 to 30 VDC) |
Operate
resistance |
0 to 1 MΩ variable
Note: The adjuster (ADJUST) on the top of the Sensor Amplifier sets the resistance for
detection within the setting range. It is factory-set to the upper limit. (Normally, the
K7L can be used with the adjuster at this setting.) |
Disconnection
detection
function * |
Detection signal: 10 VDC max., 200 ms
Detection time: 10 s max.
Recovery: Operation is recovered by resetting the power supply. |
Release resistance |
105% min. of operate resistance |
Output
configuration |
NPN open-collector transistor output with 100 mA at 30 VDC max. for both liquid leakage
detection and disconnection detection.
Note: If the rightmost pin of the DIP switch on the side of the Sensor Amplifier is set
to thedown position, the output turns ON when liquid is detected; if it is set to the
up position, the output turns OFF when liquid is detected. |
Vibration resistance |
10 to 150 Hz, 0.1-mm single amplitude with 15-m/s2 acceleration for 8 minutes
10 times each in X, Y, and Z directions |
Shock resistance |
150 m/s2 3 times each in six directions on 3 axes |
Wiring distance |
Wiring cable, Sensing Band: Total: 400 m max.
Note: These values are possible on the condition that a completely insulated 3-conductor
VCT cable with a thickness of 0.75 mm2 and a dielectric strength of 600 V is
used together with the Liquid Sensing Band specified by OMRON. (A 0.2-mm2 cable can also be used.) |
Accessories |
Product Name |
Terminal Block |
Screwdriver for ADJUST |
Terminator |
Model |
F03-20 |
--- |
F03-20T |
K7L-U/UB |
1 |
1 |
--- |
K7L-UD/UDB |
1 |
1 |
1 |